Wuben X4 modular case
Print Profile(1)
Bill of Materials
Description
Wuben X4 modular case
A simple x4 case with modular head.
It uses 4 4mm x 2mm magnets, currently there are a cover, a large diffuser and direction head
Assembly
- 4 4mm*2mm round magnets is press fit in on each component, be aware of the magnetic orientation
When inserting the case, start with an angle and slowly push it in. The case have enough flex for the torch to wiggle in
Once the head pass the angle “notch”, it will align itself straight, then just push it in
In general the side light is good for pointed area coverage, but still lack if you're trying to light up an area.
The large diffuser will work extremely good in lowest light setting
both set at low light mode
*reminder, the torch gives out a lot of heat in high setting, I recommend using ABS or PETG. The diffuser needs to be transparent so it's thicker in design, so PLA or PETG transparent will both be fine
License
You may create derivative works based on this object, provided that all such derivative works are published exclusively on the MakerWorld platform and include proper attribution to the original creator. You may not share, upload, host, distribute, or publish this object—or any derivative work of this object—on any other digital platform, marketplace, or distribution channel. Commercial use of this object and any derivative works is strictly prohibited. This includes, but is not limited to, selling, renting, sublicensing, or using the object in any context in which you receive monetary compensation or other financial benefits.
Comment & Rating (1)