Homestuck: Becquerel / Bec Fan-made Keychains

A fan-made 3D printable keychain set based on the Becquerel / Bec sprites from Homestuck.

Inspired by https://cults3d.com/en/3d-model/jewelry/bec-keychain-homestuck (I still done my sitting bec myself)

Each design was made by manually vectorizing the original sprite artwork and converting it into a clean, flat 3D-printable model. The keychains are designed for simple two-colour printing, with a white base and raised black line art on top.
 

This upload includes 3 separate plates:
 

- Bec sitting
- Bec as a puppy
- Bec as a Kernelsprite
 

The models are intended to be easy to print and suitable for fan keychains, bag charms, backpack charms, convention giveaways, or personal display pieces.

Recommended print setup:

- PLA or PLA+
- 0.4 mm nozzle
- 0.16 mm layer height
- 3 walls (4 walls for Keychain loop)
- 15–20% infill
- No supports required
- AMS is not required, But useful to have for continuous printing.

For the best result with manual swapping, add a pause before the color change, then during printing, switch to black when the raised line art begins. The black detail is raised from the surface so the design can be printed with a single manual filament swap instead of a full multicolour setup. Model's print mode in the profile is set to “By Layer” so multiple copies in bulk are best to do in 1 go to reduce pruge.
 

Shared for personal, non-commercial fan use only. Please do not sell the 3D files, printed keychains, or derivative versions of these models.

Homestuck and Becquerel belong to their respective rights holders. This is unofficial fan art and is not affiliated with, endorsed by, or officially connected to Homestuck.