Helicopter Slingshot
Print Profile(1)
Bill of Materials
Description
Membership
Do you want to print and sell my designs? By joining my Membership you get the permission to do so :)
Helicopter Slingshot - Outdoor fun!
I designed a Helicopter Slingshot! The helicopter is attached by its hook at the bottom into the rubber band of the slingshot, pulled back, and catapulted into the air! The helicopter then slowly rotates back to the ground. Fun is guaranteed!
Instructions:
PLA or PETG. A rubber band 5-7 cm long is used, ideally with some width.
Bend the rotor at the marked points (slots):
Push the small rod into the hole of the helicopter body so that it protrudes equally on both sides (center it):
Slide the rotor blade in from the front:
Rotate the helicopter body 90 degrees and slide the rotor blade under the rod:
Rotate the body 90 degrees again to wedge the body with the blade:
Clip the rotor blade slots on both sides into the notches of the body:
The helicopter is ready, now only the slingshot is missing:
Snap the rubber band into the slingshot (rubber band should be approx 5-6 cm long and have some width)
DONE!
Usage:
Hook the helicopter into the band, pull it back by holding the round end piece, and release!
Have fun! ~ Denka Designs
Boost Me (for free)
Do you like my design? Boost me to support my work :)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (7)