Rear Wing V1

Rear Wing

This spoiler was developed with a focus on aesthetics, stability, and easy printability. It is suitable for model building projects, RC vehicles, creative modifications, or as a decorative display piece.

Despite the focus on design, the current V1 version already generates downforce. In simple tests with a hairdryer as an airflow source, approximately 0.6 N of downforce was measured. These values are merely a rough guide and were not determined under standardized conditions.

Possible Applications

• Model building
• RC vehicles
• Decoration for display case, workshop, or desk
• Individual DIY and tuning projects

A V2 version is already under development. This will be specifically aerodynamically optimized and designed especially for use on RC vehicles to further improve aerodynamic performance.

Assembly

1. The two wing halves can be easily glued together with 2K adhesive or superglue.
2. The wing mounts are inserted into the designated receptacles on the wing.
3. If necessary, the mounts can be additionally glued to increase stability.
4. There is no fixed specification for attaching the spoiler to the desired model or project. The final assembly must be adapted to the respective application.

Note

The measured downforce values may vary depending on size, print quality, assembly, and air speed. The V1 was primarily designed for aesthetics and stability, but it already generates measurable downforce. The upcoming V2 will be more strongly optimized for aerodynamic performance.

Disclaimer:

• Use is at your own risk.
• This model was developed for demonstration, model building, and decorative purposes.
• The creator assumes no liability for damages resulting from printing, assembly, or use of the model.
• Products shown in the images are for illustrating size or possible areas of application only. There is no connection to the respective manufacturers or brands.