Pebble Time 2 snap-fit cover

This is a custom-designed snap-on cover for the Pebble Time 2, created to give the watch practical front-face protection without hiding too much of its original design.

I designed this because the existing 3D-printable covers I found did not quite match what I wanted. Some were bulkier than I liked, some did not have a satisfying snap fit, and others covered too much of the watch. On the other hand, bumper-only designs felt a little too exposed and did not give me enough confidence around the raised screen area.

This cover is designed to sit snugly around the raised screen section of the Pebble Time 2, giving the front of the watch a more protected edge while keeping the sides open. This allows the coloured sides of the watch to remain visible, which was important to me because I did not want to hide the character of the Pebble Time 2.

The result is a clean, practical cover that adds protection where I wanted it most, without turning the watch into something bulky.

For my own watch, I paired this with a Gadget Wraps screen protector for additional screen protection.

Recommended Print Settings

For the best fit and finish, I recommend printing this slowly with a 0.2 mm nozzle.

My best results came from:

Nozzle: 0.2 mm
Layer height: 0.08 mm High Quality

Bambu SuperTrak PEI plate for a smooth finish on the front
Print orientation: Face down
Speed: Around 15 mm/s for most speed settings
Estimated print time: Around 1.5 hours

The slow print speed made a big difference to the finish and precision. It takes patience, but the final result was worth it.

Disclaimer

This is a snug snap-on design, so results may vary slightly depending on printer calibration, filament choice, and print settings. A well-tuned first layer and slow print speed are recommended.

If you like this watch cover, please also have a look at my premium watch face on Ko-Fi, which was inspired by this cover!
https://ko-fi.com/s/04d35a758d

Your support much appreciated :-)