Black Dragon Trophy | Magnetic

I’m always improving my files, if you run into any issues please reach out before leaving a low rating. I’m happy to help troubleshoot and make improvements!

This model was designed with tabletop play in mind, my goal is to help make combat encounters feel more epic.

All files have been designed and test‑printed with a focus on a good balance between visual detail, print time, material usage, and ease of support removal. 

Please note that printing environments, slicer settings, and filament quality can vary, which may result in differences between prints. Adjustments to settings may be required to achieve the best results on your specific setup.

This model is part of a commision series that was requested by a fan. 
This model uses two 8x2mm round magnets that press fit into the back. The magnet insert is a negative part that can be removed or resized as needed. 
In my testing I have found that the most reliable print orientation is upright with proper supports. 
The model itself is about three inches from the top of the shield to the bottom. 
Display it on your fridge or any magnetic surface, distribute them to your players as a reward for finally conquering that dragon, or use them as a wall trap for your battle maps!
I hope you enjoy!

Like what you see here? Check out My Profile for more awesome things to print!

Got a creature you'd like to see that I don't have on my profile yet? Drop a comment with a suggestion!