Skadis - Geeboon TC22 Soldering Iron Station Mount

I am back again with a new skadis design!

This design is based on the Geeboon TC22 Soldering Station, and acts as an easy-to-use mount for the IKEA Skadis punch-hole wall.

The mounting bracket features a small cut out to route the cable going to the iron holder to avoid too much cable strain.

The design is fairly simple:

1. You connect the needed wires to the soldering station
2. The soldering station is pushed into the holding case
3. The skadis mounting bracket is attached to the back of the device
   1. Alternatively, you can mount the mounting bracket to the skadis wall first
4. You mount the device on the skadis wall
5. Done!

The print uses approximately 150g of filament, takes about 4.5 hours on the P2S and should easily fit on even an A1 or similar printers.