SunPass Pro - Holder

Information:

Suction cups are the worst right? Welcome to the Sun Pass Pro mount.

I designed this so the transponder would slip in and stay put. The backside of the mount has a tiny lip to keep it from falling out when hitting any bumps. 

Note: This was printed in ASA, and I set the speed to Silent (50%) for a clean print. Make sure you use Elmer's Disappearing Purple School Glue to keep it planted on your build plate.

I've included the STL file if someone wants to update or customize.

Print in Place: 

Yes

Required Hardware:

Velcro: https://www.amazon.com/dp/B0D29TWPN4
Glue: https://www.amazon.com/dp/B00143SNPG

Assembly:

• Apply Velcro to the back of the mount (check photos), and install in your vehicle.