Hex Benchy Shelf with Labeling

A Benchy shelf with holders for dragon eggs and dragons to display the special colors of 2-, 3- and 4-color filaments

The Benchys are attached hanging (on the chimney) and cannot fall out

The connectors are designed to be tight and must be hammered in with a rubber mallet. This avoids glue and holds very well.
Make sure to place the connectors straight before hammering them in!
I have attached the FreeCAD file for the connectors so that they can be adapted

The labeling is designed for 30mm x 20mm labels.
For this purpose, I bought a label printer (30€) on Amazon https://amzn.to/49JPBSF (affiliate link).
The Amazon labels: https://amzn.to/4uas1H9 (affiliate link) 320 pieces 13€.
This works quite well with a mobile phone (Android). Unfortunately, it is not really suitable for PC (or I don't know enough)

These were used as dragon eggs: https://makerworld.com/en/models/778792-dragon-egg-fits-30cm-dragon-designed-by-me#profileId-724518

With this scaling, the 30cm dragons fit well into the egg.
 

If you have questions, just ask :-)

The model was inspired by https://makerworld.com/en/models/2144448-the-hexa-link-precision-modular-shelf-system#profileId-2322993.
ATTENTION!! These are not compatible with each other.