G4/G6 Instant foldable Unifi Travel Router stand

Combination Travel stand for G4/G6 Instant camera and Unifi Travel router.

• Prints cleanest with PETG for main unit and PLA or other support interface.
• there are two break away tabs marked in red in the pictures that need to be removed before the camera can be attached.  Clean up any left over debris with flush cutters or XActo knife.
• This is a print in place model and will require a bit of effort to get the travel router receiver to twist after the print is complete and all support material is remove.  Expect to put a bit of muscle into breaking it free for the first time.
• The travel router should be a friction fit into the mount.
• If you're all about keeping your travel router nice and shiny this likely isn't for you.  The router is friction fit into the case so will show wear marks over time and the other end acts as the leg for the camera so it will get table marks on it, see pictures what I'm describing is minor and for anyone using as a tool is likely negligible.  Can probably put rubber feet or helicopter tape on it if you're overly concerned but buyer beware.  Picture showing the wear is from a couple of weeks of daily testing and is really just dirt marks from me sliding it around on the desk.