Search models, users, collections, and posts
Asanoha Pattern Coaster & Mini Charm Set
IP Report
Print Profile(3)
Coaster (88mm) â 0.2mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
Mini Charm (30mm) â0.1mm layer, 2 walls, 15% infill
Designer
37 min
1 plate
Mini Charm (25mm) â0.1mm layer, 2 walls, 15% infill
Designer
30 min
1 plate
Open in Bambu Studio
Boost
0
4
0
0
1
1
ReleasedÂ
Description
This is an Asanoha (traditional Japanese hemp leaf) pattern coaster designed at 88 mm diameter.
It works well with cups, mugs, and similar items, adding a decorative touch to your table.
Suitable for light use. Please note that PLA may deform under high heat, and the open design allows moisture to pass through.
For best results, it is recommended to print at 60 mm diameter or larger.
Scaling below 60 mm may cause the pattern to lose detail or become unclear.
Mini versions are also included for smaller prints:
30 mm version
25 mm version
These are optimized for use as charms or small decorative items.
If you like this design, I would really appreciate your support with a like or boost! đ
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)