Face Saving Phone Stand and Mount
Print Profile(1)
Description
This stand does it all. Tired of dropping your phone on your face in bed? or waking up to your phone scolding hot smothered by blankets because you fell asleep watching youtube? So was I. Presenting the fully adjustable phone stand and mount. The ball is easily positionable to get your perfect viewing angle and simply tighten the set screws on the top and bottom. The slide on the side can be adjusted to accomodate for small or large phones. I also did not want the stand fixed to the wall all the time so i designed a base plate to easily slip the mount in and out of. Which means it can also be used as a table top phone stand anywhere in your home, or print more bases to place through out your home for easy viewing while cooking, painting, projecting, etc.
Print/Assembly instructions
1. Print with 0.4 nozzle using 0.16mm optimal setting With Supports.
2. The ball may need minor sanding where the supports were for smoother rotation
3. Everything should be slip fit depending on your printers tolerances
4. if slip fit is too loose; use a small dab of glue on the post and insert post into ball
5. The Ball is tough to slot into the enclosure, The relief slits allow just enough flex to force the ball in with pressure. (Be Careful)
Boost Me (for free)
This model took me a lot of renditions and a lot of filament to get correct, I hope you enjoy it as much as i have been
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)