Bambu Lab spool holder rescue
Copyright Claim
Bambu Lab spool holder rescue
Boost
60
101
31
Print Profile(1)
0.2mm layer, 3 walls, 30% infill
2.8 h
1 plate
Open in Bambu Studio
Boost
60
101
31
4
238
122
Released
Description
The original Bambu Lab spool holder is such a pretty piece of metal I couldn't bear to put it away in a drawer forever since it goes to the worst possible place on the machine…
So, I gave it some feet :)
You will need 2 M3x10 or 12.
Personally, I ran an M3 tap through the holes but if you drill them a tad bigger you might just screw it in.
I printed it with 3 walls for strengths in PLA.
No support needed, extra cooling is best.
UPDATE: Version 2 is thicker, version one when placed just by a Bambu printer starts vibrating with it because of the crazy speed! So, I made V2 beefier :)
Comment & Rating (31)
All
The print profile is no longer public
I stripped the heads of the included Allen key screws... oops. They do not handle any higher torque well, and turns out the holes in the print were a bit undersized. Anyway, I just drilled out the holes to 3mm and used an M3 nut and bolt to get the spool holder onto the print. Has been working well for me, thanks.
1
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Great profile. Came out good and clean.
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
works perfect. easy and simple montage.
0
Reply
The print profile is no longer public
Great print!
0
Reply
The print profile is no longer public
works perfect
0
Reply
The print profile is no longer public
Very nice design!
(Edited)
0
Reply
The print profile is no longer public
0
Reply
The print profile is no longer public
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Strong print that works well for the auxiliary spool.
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Great way to repurpose the spool holder that came with the p1s
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld