Search models, users, collections, and posts
Bar Clamp Rack
IP Report
Print Profile(1)
0.8mm nozzle, 0.4mm layer, 4 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
6
34
0
0
4
2
Released
Description
A rack for bar clamps. The two countersunk holes are for #10 wood screws, but you could probably use as small as #8.
Print two of these racks and affix to wall/cabinet either side of the pivot point of your clamp to hold them perfectly upright (see pics).
I've printed in both PLA and PETG on a Bambu A1 with a 0.8 nozzle for strength, but I'm sure 0.4 would be plenty strong given the triangular geometry offers very good support all the way to the end of the rack.
Original OnShape doc if you want to remix for any reason: https://cad.onshape.com/documents/2256e23cb814f6c1c00e5959/w/ad2dc26c4ef309a71c7a5864/e/c42fd4af3ca6371074c146f2?renderMode=0&uiState=69f66b9e5167709b0a81dc77
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)