Dragon on the Crag

You can check all of my other unique designs here!

My hueforge models are right here!

Clean, detailed dragon FDM print — but don’t let the looks fool you, this one fights back a bit.

Difficulty: 6.5/10
This model prints beautifully with the right setup, but it’s not beginner-friendly. The main challenge is the supports, especially under the wings. Those areas are thin and fragile, so removal needs patience — rush it and you will snap something.

Tips:

• Let the print cool completely before touching it — warm plastic = easier to bend or damage thin parts
• Don’t just rip supports off — wiggle and “peel” them gradually instead
• Use good lighting while cleaning — you’ll catch tiny support leftovers before they ruin the finish
• Light sanding (very fine grit) can clean up rough spots without killing detail
• When removing supports under the wings, take it slow and use proper tools (flush cutters recommended)
• A little heat (like warm air) can help soften stubborn supports without stressing the part

Ideal filaments if you are not painting it: 

• Matte black
• Matte white
• Light grey
• Marble

Once cleaned up, the detail really pops — perfect candidate for painting or display as-is.

Not impossible, but definitely one that rewards careful hands.