Search models, users, collections, and posts
1lb Solder Spool Holder for Silicone Soldering Mat
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
32 min
1 plate
Open in Bambu Studio
Boost
0
1
0
0
1
0
Released
Description
Tired of chasing your solder spool across the bench? This holder drops into the square recesses found on common Chinese silicone soldering mats and stays put while you work.
Designed to fit a standard 1lb solder spool with a small slot on the side that keeps your solder feeding out at a consistent angle. The accidental bonus - the slot perfectly captures a roll of solder wick and holds it right where you need it.
Fits mat recesses approximately 44mm x 48mm. If your mat recess is close but not exact, scale X/Y in your slicer to match.
Printed in PLA on a Bambu X1C. PETG recommended if your bench gets warm.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)