Huge Articulated Kraken 20mm Eyes
Print Profile(1)
Description
Boost Me (for free)
If you enjoyed this model in any way, please consider leaving a boost. It greatly helps me continue to make models!
This monster of a creation can reach over 2 feet and is quite heavy. If it's going to be dragged around or played with a lot, I would recommend increasing the walls. Note that this entire build will require at least 2 rolls of filament to keep the color consistent.
All are sized on the H2D, you could shrink it slightly to fit on smaller printers, just adjust the negative cylinders so the eyes still fit.
You will need to print 8 of the arms, then print the top and bottom of the head. It should slot in just fine, but I recommend some E6000 or other adhesive to help hold it together on each of the arm rings and the middle head connector.
Note that on each arm, the white suction circle at the tip will stay stuck to the build plate. I am too lazy to fix it and it actually makes the arms look better in my opinion.
This remix is based on
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (14)