Search models, users, collections, and posts
TPU Boot, Cover for Milwaukee 2557 3/8" Ratchet
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Open in Bambu Studio
Boost
5
11
1
0
1
1
Released
Description
Boost Me (for free)
I'm just a geezer doing 3D printing and design to keep my brain active until I start CTD or become DRT. A little positive attention keeps me going. For you non old school emergency personnel, or those who only know modern approved abbreviations:
CTD is Circling the Drain and DRT is Dead Right There
Cheers!
This is a protective boot for the Milwaukee 2557-20 M12 ratchet. This version is to be printed in TPU. I have posted a version for hard filaments like PETG for those who do not print TPU. The cover has two pieces; one is the cover itself, the other being a “key” that fastens the seam closed. A zip tie can be used as an alternative, if desired.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)