Crafted Reyna Earring Set Earring Stand Ear Cuff Earring Storage

This is the third piece in the Reyna COS series, featuring Reyna's iconic earrings.

Based on these earrings, I also designed matching ear cuffs.

For storage, there's also a stand. This stand features the Valorant logo.

Printing:

Before printing, please thoroughly wash your build plate with warm water and dish soap. This is very important.

Because the ornament requires high precision, detaching from the build plate can easily lead to print failure.

The contact surface of a single piece is small, so printing may likely fail. It happened several times during my attempts, so be prepared.

Since Bambu Lab MakerWorld does not allow uploading custom materials, my current slicing profile is set to the preset PLA Silk+ material.

If you want to use the same 99 gold as me, please contact Caiduo House customer service to download the preset.

The stand's preset is PLA Galaxy purple.

Assembly:

You need to purchase DIY earring accessories of this type on Pinduoduo. You can search for 'DIY earring accessories'.

I bought a whole box, and this bright gold color is more suitable in comparison.

After sticking all the components, you can complete the assembly by passing the small round clasp through the printed holes.

The outer side of the ear cuff is printed with brim, which is very important for printing. I do not recommend turning it off. However, this will cause slight burrs after removal.

I recommend heating the burr parts with a blowtorch before use. Due to the material, do not heat for too long, or the gold color may change.

I also prepared two sizes: large opening and small opening. I tested both, and they are usable. The small size might be a bit tricky to put on.

Please refer to the image below. There is a recessed area below the ear; snap it in and then push upwards. This way you can perfectly wear both ear cuffs.

Commercial use is strictly prohibited.

——————————

Happy printing