Print Profile(3)
Description
Update
16.06.2026
- Reinforced the propeller blades,
- added a new base,
- slightly extended the broom handle.
Overview:
Wind spinner inspired by Harry Potter
Instructions:
The full set consists of several parts.
Wizard: hand-painted in the print profile. It uses only two colors, so it’s perfect for H2C or newest X2D. You can also print it in a single color.
Spinner: glue the blades to the spinner and mount it at the end of the broom. A small arrow-shaped pin secures the spinner and should also be glued in place.
Place the wizard onto the broom. It’s a tight fit, so no glue is required. Position it carefully to achieve proper balance. The whole model should stand as shown in the photo.
Base: screw it to a post and insert the broom with the wizard.
If the model is too big for you, you can make it smaller. I printed a 50% reduced version and everything works the same. Only the propeller blades need to be printed on a 0.1mm layer. I also added a print profile with a smaller version.
Have Fun :)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (135)