Print-in-Place Webcam Cover for Microsoft LifeCam

A print-in-place webcam cover for the Microsoft LifeCam. It clips onto the camera and lets you physically block the lens when you’re not using it. The model uses about 5 grams of filament, so it’s a quick and cheap print.

The hinge is fully print-in-place, so there’s no assembly needed. Just print it and it’s ready to go.

If the hinge is stiff at first, just move it back and forth a few times to loosen it up. You can also add a bit of lubricant if needed.

Note: there are at least two variants of the LifeCam that I’m aware of, one with a 29 mm diameter and one with a 27 mm diameter. I’ve added print profiles for both variants.