Axial SCX24 Axle Mounts for PROFESSORBOOTS RC Semi

This is an Axial SCX24 axle and motor mount set for the Professor Boots Rc Semi Truck project. I didn't want to use the extensive electronics that he uses in that project, so I came up with my own. I am using a stock Axial scx24 receiver and transmitter, stock front and rear axles, a 6x6 conversion kit from amazon, and the stock motor, trans, and skid plate. These are compatible with axial scx24 axles. They fit snug, and use existing axial mounting holes and screws. You will need to drill the holes, I recommend a PCB drill bit set for about $10 on amazon. The mounts include 2 rear axle mounts, you'll need to supply the 6x6 kit. Works well with stock axles and stock driveshaft. The front axle mount isn't perfect but holds well. Ill be upgrading it soon. The motor mount piece can be screwed anywhere on the truck to give your driveshafts as much room as they need. The motor mount uses the stock skid plate, slide it on and screw it in. Super easy setup, just a little hand drilling and driving screws. I used stock m1.4 axial screws for the skid plate and where the mounts connect to the axles, and the 2.0 screws used in the professor boots instruction kit. Printed on Creality Ender 3 s1 pro, .2mm, 40%+ infill. I chose 100% because i wanted a tight hold on the threads, but you don't have to go that high.