Cane Holder with clip on base for Walker

🦯 Cane Holder Clip for Walker – 3D Print STL (23mm Tube Fit)

Keep your cane secure, accessible, and off the ground with this simple and practical Cane Holder Clip. Designed to attach directly to a walker or similar mobility device, this holder keeps your cane upright and within easy reach—no more bending down or searching for it.

Perfect for everyday convenience and added independence.

🧩 What’s Included:

• 1 STL file (single-piece design)

🖨️ Features:

• Clips securely onto round tubing
• Designed for ~23mm diameter poles (common on walkers)
• Built-in cradle to hold cane tip or shaft
• Open design allows quick access and removal
• Compact and lightweight
• No assembly required

⚙️ Print Notes:

• Recommended material: PLA or PETG
  • PETG preferred for added durability and flexibility
• No supports required
• Print with higher wall count (3–4 walls) for strength
• 20–40% infill recommended
• Print orientation: flat on base for best strength

📏 Fit & Compatibility:

• Designed for tubing around 23mm diameter
• Slight flex allows for a snug clip-on fit
• May work with similar-sized poles (±1mm depending on material)
• Can resize it to fit other tubes

🎯 Perfect For:

• Walkers & mobility aids
• Keeping a cane off the ground
• Seniors or anyone using assistive devices
• Everyday convenience and accessibility

🖨️ Additional Notes:

• Fit may vary slightly depending on printer tolerances and material
• If needed, scale slightly for a tighter or looser fit
• Designed for easy installation—just snap onto the frame
  • I used a bit of double sided tape to keep it from slipping