Mini Wobble Bear - NEVER FALLS!!! (26 mm height)

🧸 The Little Bear That Never Gives Up!

Need a desk companion that refuses to stay down? Meet a 3cm mini bear that hides a "heavy" secret. By embedding a metal bolt during the printing process, its center of gravity is so low that it will always pop back up, no matter how many times you flick it!

✨ Project Features

• Height: 26 mm.
• Design: Optimized for support-free printing.
• Mechanism: Uses physics (and a bit of hardware) for an instant Roly-Poly effect.
• Print Time: Super fast (less than 30 minutes on most machines).

🛠 Assembly Instructions (PAUSE PRINT)

To achieve the "always upright" effect, you must insert a bolt inside the bear during the printing process:

1. Slice the file and locate the layer where the internal cavity is about to be closed.
2. Pause the print right BEFORE layer 39: at 12 minutes from the start of the print.
3. When the printer pauses, drop the bolt into the slot.
4. Resume the print and watch the printer seal the "steel heart" inside!

Pro Tip: Ensure the bolt sits flush within the cavity and doesn't stick out to avoid the nozzle hitting it when it resumes.