Non Filament Bending Spool Clip

I always disliked how basically every filament role has the holes on the side for making sure the filament doesn't roll out. Sure, it's easy to produce, and works, but I wanted  something that didn't bend the filament  and was easier to use.

That's why I made  this little clip! You can simply press the filament into it, and pull it out easily without the filament getting loose! Putting  it on the spool  is easy too, especially with a bambu spool! (Or one that has the same shape). You simply print a few bambu-spool version clips, and you can pop it right on! Don't have a spool in that shape?  Just use the flat version and add some double sided tape!

NOTE:

 You currently can only use the flat version if you use an AMS. The Bambu spool clip works fine on the AMS-Lite, but it doesn't work on any AMS that needs the round outside/walls of the spool. I will try to make one that can fit inside the Bambu spool without any adhesive while still being fully internal. (Nothing poking out)

I recommend printing it in PETG to get it's strength and bending durability (which is needed), and not changing the orientation of the part. It's also only for 1.75mm filament, but that's basically every single roll.

I used bad and old PETG for this, so I'm sure it will print successfully for  you!