DESKFINITY Modular Desk Organizer System

 IMPORTANT:

 ✓ Enable supports
 ✓ Place supports on build plate only
 ✓ Support top Z distance: Increase the second decimal of your layer heightby 1 (e.g. at 0.20mm layer height → 0.21mm distance)
 ✓ Top interface layers: 2

 DESKFINITY is a modular desk organization system built around a precise
 snap-fit grid. Every module locks securely into place, no tools, no
 adhesives, just print and click.

 The Baseplate is where it all starts. It spans a 7×5 grid 
 and serves as the foundation for the entire system. Every container,
 holder, tray, and accessory in the DESKFINITY lineup is designed to
 attach directly to this base. The bottom features dedicated spots for anti-slip rubber pads, keeping
 the whole setup firmly in place on your desk, no sliding, no shifting.

 What makes DESKFINITY different from a standard desk organizer is the
 modularity: you decide what goes where. Rearrange at any time. Swap
 modules out. Grow your setup gradually. Print only what you actually need.

 This is the starting point. Browse the full DESKFINITY collection on
 MakerWorld to build your own layout.

 Container M (2×2) 

 A reliable everyday organizer for your desk the DESKFINITY Container M
 fits cleanly into any 2×2 section of the Baseplate and holds the things
 you reach for most.

 The footprint is compact (47,3×47,3mm), but the depth is practical: pens,
 markers, scissors, small tools, and everyday accessories all sit
 comfortably upright or flat inside.

 Every container in the DESKFINITY system is designed with the same grid
 pitch, so modules sit flush and stable with no gaps between them. The
 result is a setup that looks intentional, not improvised.

 Mix and match across the full DESKFINITY lineup.

 Requires the DESKFINITY Baseplate.