Baby Maggie

Baby Maggie

Along time ago on a printer far far away….. 

Printed in parts, NO AMS needed. Model is approx 6cm tall at 100% in the print profile for ease of assembley. Printing it smaller is possible however small parts will be difficult to print and assemble.

Keep an eye out on my page for future releases comming up in the next few weeks;

📌 Recommended printing settings:

• Material: PLA
• Layer height: 0.16 mm
• Infill: 15%
• Nozzle: 0.4mm

supports where nessesary - I have tried to make it so all have a surface contacting the plate however due to the detail and complexity of the modeling they sometimes require alot of support, so be aware and be carefull during support removal. Use a naked flame gentley and for short intervals to clean surfaces after removal

Assembly – Recommended Method on multipart models

• Dry fit: Assemble all parts without glue to check alignment and fit.
• Cleanup: Lightly deburr edges and pegs where nessesary with a file/modeling tool to ensure uniform contact. All parts are tested and fit together.
• Optional fix: Use glue for permanent assembly. This Is Highly Recommended!

Eye lashes are extremely fiddy, a dot of glue on the end and gently put in place and hold the head still while it dries enoguh to put down. do a couple at a time and fit the eyes in the head first to give you more to work with!

NOT AI, NO AI COLOUR PICS WHICH DISGUISE A POOR DETAILED SINGLE COLOUR PRINT. REAL PRINTED RESULTS!

MOST OF MY MODELS ARE FAN ART RECREATIONS AND ARE FOR PERSONAL USE ONLY  : MY MODELS ARE UNOFFICIAL FAN ART AND ARE NOT AFFILIATED OR ENDORSED BY THIRD PARTY IP HOLDERS

Thankyou to everyone who has rated and boosted my prints, if you like the models and want to continue to support the creation of more please consider boosting, it really does help incentivise the creation of more models for makerworld. 

If you would like to "buy me a coffee" to support the continued creation of fun prints you can do so here;

All of my models posted here are free for you to use commercially for free. I make them as a hobby and a bit of fun, with the points helping supply filament and consumables. All i ask if you wish to support my designs and want to sell them is that you are aware of the IP infringement which apply to some of the models and take appropriate responsibility. Please also boost them as much as you can and help with the points and please correctly attribute the model design to this page in your descriptions etc - Thankyou again everyone!