Search models, users, collections, and posts
Florball ball
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
1.5 h
1 plate
Open in Bambu Studio
Boost
55
113
13
3
302
167
Released
Description
I could not find a suitable 3D printable florball ball, so i made my own.
A simple florball ball, but really close to the real thing.
Was quite tough to design it in fusion 360, but i managed to pull it off.
The design is dialed in to print with PLA, PETG, ASA and ABS.
With simple PLA, it might be too brittle and shatter (which happened to me), but PETG/ASA/ABS should hold up.
With the right file, the ball will always weigh around 26g, which is the standard.
Put some paint-on supports on the bottom of the ball.
Boost Me (for free)
Like my models? Boosting always helps out!
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (13)