Search models, users, collections, and posts
Stair Handrail Cover
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
0
1
2
0
2
1
Released
Description
This model is to cover the part that connected my handrail to my wall. Before, it was an ugly mess of screws and visible wall anchors. With this, it looks finished. The downloadable project has a center that is sized at 41MM. The handrail I bought off Amazon has a square piece that is 40MM all ways. Printing this in PLA, as is, creates a snug fit. The secondary piece is sized to pressure fit. Careful, it takes some force to remove it once it is placed all the way.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)