PO-12 Rythm Case

READ BEFORE PRINTING

• Pay attention to the build plates and use the appropriate nozzle in each case:
  • The button parts are designed for a **0.2 mm** nozzle
  • The rest of the parts are for a **0.4 mm** nozzle
• The light guide must be printed in transparent material
• The buttons require a small post-processing:
  it is necessary to remove a thin filament strand with a utility knife During printing, this strand deforms downwards, but it serves as support for the upper layers
  

Any suggestions, contributions, remix, or complaints will be welcome as long as they are constructive
Also, any comments, photos, ratings, and/or boost will be greatly appreciated 😊

This model is inspired by another model that is not part of this community
https://www.thingiverse.com/crashdebug/designs

Please take a look at their profile, which is very interesting