Search models, users, collections, and posts
RFID RC522 Case
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
35 min
1 plate
Open in Bambu Studio
Boost
47
125
3
5
184
117
Released
Description
A sleek, snap-fit case designed specifically for the RC522 RFID Reader module. Perfect for Arduino/ESP32 projects, home automation, or access control systems.
Features
- Perfect Fit: Tolerances designed for standard RC522 boards.
- Cable Management: Includes a cutout for jumper wires or soldered pin headers.
Minimalist Design: Low profile to ensure maximum read range through the plastic.
Print Settings
- Material: PLA or PETG
- Layer Height: 0.2mm works great.
- Supports: No
- Infill: 15-20% Grid.
Assembly Instructions
- Put the RC522 board into the base.
- Route your wires through the Back exit port.
- Snap the lid into place
- Note: Ensure your pins are at a 90-degree angle to fit this specific version.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (3)