Search models, users, collections, and posts
Wallmount for Netear M5 Mobile 5G Router
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill, supports enabled
Designer
1.8 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
5
18
1
0
32
31
Released
Description
This is a model created by stv0g:
https://0l.de/blog/2022/06/netgear-m5-wall-mount
https://codeberg.org/stv0g/3d-printing/src/branch/master/netgear-m5-wall-mount
Renders:
Assembled Mount:
Antenna connectors:
This mount includes two holes at the bottom which align with the TS9 antenna connectors.
I recommend to use TS9 to SMA adapters which can be screwed into those holes
https://www.amazon.de/-/en/Antenna-Adapter-Straight-Connector-Broadband/dp/B08RYZ811X
Foam padding:
The inside of the mount has a clearance of about 1,5mm against each side which can be used for padding the device with foam rubber.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (1)