modular slim 10 inch / Inch Server Rack 2/4/6U

Hello,

For my purposes, I have created a slim modular 10-inch server rack.
The height can be assembled as desired for its purposes from the supports. You can freely choose from 2, 4, and 6 U / RU.
The system is designed so that as few additional screws as possible are needed, and where possible, I have hidden the screws and nuts in non-visible areas. In addition to the filament, only standardized M6 nuts and screws are required.

In my examples, I have printed one rack without a lid and one with a lid, base plate, and feet. It's an option, but not a must. The partially equipped rack is my prototype, with which I tested the constructions, filaments, and print beds; the one with the feet will be my final rack. Personally, I got the best results with matte PLA; PETG also worked, but I didn't find it as appealing. You can freely experiment there.

No AMS needed!
If you want an open top and/or bottom rack, print the “open longitudinal supports”; if you want a lid and/or a base, print the “longitudinal plate holders”. These have a nose that holds the plates.

I will optimize, improve, and expand my rack in the future, but that will happen over time. So feel free to check back occasionally.

If you have any questions or suggestions for improvement, feel free to contact me!

Have fun with it!