H0 Buffer Stop (Märklin Compatible / Clip-On)

Realistic Buffer Stop for e.g. Märklin H0 scale (C-Track, M-Track compatible)

Do you need a sensible end for your sidings without spending a fortune This scale buffer stop is a cost-effective and highly customizable alternative to the original

It deliberately foregoes the often unrealistic sand pile that is standard in many commercial models and thus fits much better into station scenarios or modern layout designs

• Modular Design: The buffer stop consists of individual parts This means for you: Absolutely no printing support needed!
• Minimal Filament Waste: Due to the individual parts, color changes in the slicer (AMS) are limited exclusively to the red and white warning bar This massively saves printing time and reduces filament waste to an absolute minimum
• Rock-Solid Hold: The frame is not just placed on the track but firmly clipped in It snaps into place and is then difficult to move Even if a train docks a bit roughly, the buffer stop remains in place
• Maximum Flexibility: Since it is independent of the actual track piece, you can attach it anywhere on your track network – even on curves without any problems!

Assembly: Assembly is simple and self-explanatory (see photos):

1. Print parts in desired colors
2. Hold the red and white warning bar against the black frame
3. Insert the two buffers through the holes of the bar into the frame (Tip: To avoid damaging anything during assembly, it is easy to insert A small drop of superglue makes it even more stable)
4. Press onto the track until it firmly clips in Done!