Twisty Stim Fabled Fidget Family (4 Options)

Join Patreon as a free member to catch new releases & free-to-sell models.

Prowl with 1k+ foxes & ~300 authorized sellers in our Skulk!! 🦊

Friendly Reminder: An active commercial license is required to sell prints of my non free-to-sell models.
>> (My partner and I offer many models you can sell for free!) <<

I'm an ADHD husband, father of 5, QA engineer, market vendor, & self-taught designer.

Thank you for backing my family of 7 & honoring the thousands of hours I've poured into this! 🖤

---

[Gif was made with permission from george_gkrimas. Go check them out on Instagram!]

Notes:

• 4 stimulating options (my wife's fave is Spiky & mine is Pebbly)
• Measued it at about 45cm when fully extended (it is < 9cm tall!)
• 20 vertical, sliding pieces (up from 12 on my twisty balls)
• I have printed dozens of these to optomize ease of printing (but there is still a chance you may have to “break it in” due to filament expansion/printer variance & possible build up around the seams)
• Prints with 
  • A center “throw away” piece so it's not knocked over during printing
  • A full brim
  • A single 0.55mm wall (to reduce the amount of filament expansion & to drastically decrease printing time while maintaining strength)
  • 0% infill (the walls are so close I would expect great strength - as long as you are achieving good inter-layer adhesion)

---
If you like & want to support my work, you can always..

• ⚠️ May have sharp or pointed features that could cause discomfort or injury if handled carelessly
• 🧩 May contain small parts and present a choking hazard
• 👶 Not for children under 3 years of age
• 🧠 Recommended for mature users
• 🤕 ToddysTrinkets is not responsible for injuries resulting from use
• 🛑 Use at your own risk