Panda Den Kallax Feet P1S

Got myself a Panda Den from BIQU. Had my P1s on an Ikea Kallax unit with my printed feet so it couldn't fall off. So I wanted to apply the same idea to the Panda Den.

These feet replace the supplied factory feet on the Panda Den and allow it to sit on a Kallax unit safely so it can't slide off the front or back.

The Panda Den is of course deeper than a Kallax unit, so it will overhang at the back (see photos). If required, you could put the feet on the opposite way around, but the Panda Den and printer would then overhang the front of the Kallax by quite a bit and I'm not sure how stable that would be - so you do need a bit of clearance behind the Kallax.

The main feet were printed in PLA with 25% gyroid infill as the Panda Den and printer are quite heavy.

I didn't buy the anti-vibration feet, and you don't have to have these - the P1S will sit quite happily on the Panda Den, but I wanted it to at least be 'located' if not actually fixed to the Panda Den. So there are four round foot 'cups' that attach to the Panda Den using the anti-vibration feet mounting holes and supplied screws. I printed these in TPU to add a little vibration damping.

Hope you can get some use from these.