Search models, users, collections, and posts
JDM to USDM Plate Adapters - 6g Filament Only!!
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill, addtl top/bottom shells
Designer
22 min
1 plate
Open in Bambu Studio
Boost
6
18
0
1
34
32
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Description
Reduce your printing time significantly by using these individual plate adapters for each side as opposed to a full license plate frame. Cut your time in half to only 15 minutes total print time for a set of adapters that only uses 6g of filament!
Each Plate Adapter has been modified and beveled to create two symmetric mirrored pieces to create a set of adapters while keeping the nice rounded edges.
Recommended hardware:
M5 flathead screw
M5-0.8 8mm screw for license plate
Save filament, save time, save money!
Note: Printed with PETG Basic. Profile Settings are for PETG Basic. You could probably use standard settings for PETG HF.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (0)