Helmet station (motorcycle)

Motorcycle wall mount station

Up to 20 kg can be hung on the lower hexagons (distributed weight and mostly adhered to the wall) and it has capacity for 2 helmets, as well as anything placed on top of the red table, such as keys, gloves, chains, etc

You will need the following materials

1. PETG filament (to provide the mechanical strength and flexibility mentioned above)
2. Cyanoacrylate glue
3. 2 #12 screws with their concrete anchors (The solution shown in photos is mounted with 2 screws, it is optional if you want to add the other 2 in the remaining slots)

Now, the assembly steps are as follows

1. Splice “Base_der” with “Casco_der” and the latter with “Base_Casco”, the same with the left sides “izq”. All of these must be secured by applying at least 3 drops of cyanoacrylate glue to each splice

   

2. Align the holes of the left or right assembly and with a single screw with its anchor, begin to fix it to the wall (Start without going all the way in, in order to leave it as vertical as possible) 

    

3. Now place the table, simulating the position of the remaining side, in order to mark the position in that piece's hole where it will be fixed with the screw and anchor (Verify that the table slides easily without forcing it when trying to insert or remove it from its place)

   

4. Once the table is mounted, proceed to fix it with its respective screw, always leaving it a bit loose at first to keep the remaining piece as vertical as possible (It is optional to add cyanoacrylate to the table, this is up to your preference. In the main image, it is not added and there is no risk of it coming off)

5. Hang whatever you want (without excess) and enjoy this gift from me to you ;)

   

I hope you like it very much and see you in the next design :D