Search models, users, collections, and posts
Air filter tower for LD-002H & LD-002H
Remixed by
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
2
1
0
0
0
0
Released
Description
Summary
This is a remix from Air Purifier Plus but this is intended to get air out of the machine after proper filtration in order to renew air and also get a negative pressure un chamber borders.
Base of the tower must be a 4010 fan or the fan plus the original filter since this is attached with screws.
You could do and freely move any combination after that.
My combination is, from bottom to top:
- LV0: Original filter
- LV1: Original 4010 fan
--- Removable parts from here - LV2: Carbon sheet (10mm)
- LV3: Carbon pellets (80mm)
- LV4: Carbon sheet (10mm)
- LV5: 4010 fan
- LV6: Top grid
It's recommended to put a sheet at the bottom of the pellets section if there is no other filter after these because small pieces of pellets may fall on next sections otherwise.
Final note: You may need 4-8 small washers for fan+filter base or other screws for fan-only base
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)