Grumpy Schokohase

It's not even Easter yet... and I'm already being bitten! 🐰🍫
Here comes the Grumpy Chocolate Bunny — probably the only bunny grumpy not because of calories, but because of its ears.

On the left, he's still prim and proper like he just came from the confectionery, on the right... well, let's just say: Should one still look happy with a bitten ear? Exactly. No amount of icing can sweeten that mood. I think he's already counting the days until Easter is finally over and he can grumble chocolatily in peace again.

⚠️ Important note!!
No requests for a multi-part version — yes, it's printed with support, but it's very easy to remove depending on the filament.

I printed with BambuLab PLA Matte Dark Chocolate, Ivory White, and PLA Basic Black.

There are again two different versions:

🐇 The chocolate bunnies are 120 mm tall, but can of course be scaled according to personal chocolate craving.
Everything was printed with a layer height of 0.16 mm and a 0.4 nozzle.

In each profile, there are bunnies with Fuzzy Skin (only included in the 3mf) and one without Fuzzy — entirely to your taste, whether melt-in-your-mouth or extra crispy.

🍫 Version 1: One Color
For all with extreme chocolate cravings who can't wait.
Here you can get creative with painting — or just let it grumble naturally.

🎨 Version 2: AMS with three colors
Yes, it generates filament waste and the printing time is longer... but good chocolate also needs to mature.
It's best to print several at once on a plate, then the waste is easier to bear.

🤖 For my special AI trolls:
Drawn with Adobe Photoshop, then Adobe Firefly and somewhat edited with Nomad Sculpt.
If that's already too much AI for you, save your comments and just get some other chocolate 😉

If you like my work, I would be thrilled about feedback, a like, or a boost.
And remember: Watch your ears... otherwise, you'll end up looking just as grumpy 😄🍫🐰