Elgato Wave3 Microphone and Stand Box

This is an insert designed to snap-fit into Whity's parametric rugged box for the Elgato Wave3 Microphone and stand. I wanted somewhere I could store the stand without it being scuffed or lost, so I created the insert to house both. This is mostly meant for flat/non-moving storage purposes, but I've included a stopper block (final photo) that can be used to ensure the base doesn't move around much, and foam can be attached to the inner top of the box for further protection.

Yes, I am aware the logo is off centered and upside down in my photo. Yes, I did make an attempt to correct the orientation in the slicer after printing. No, I cannot guarantee it is perfectly centered now, but it can be removed if desired.

Screw holes on the rugged box are 3mm, I utilized Tutu's M3 Screw kit, specifically the philips's head screws. I may have been dealing with some shrinkage issues, I had to scale the 6 screws needed up to 109.35% on X & Y axis for them to work, but they're good now. I used PLA, but PETG is probably recommended for increased strength/durability. 

Firmly press the insert into the box base when printing is completed, snap-fit spots will lock it into place.