CleanStack Wet Boot & Shoe Rack

The design stacks boots/shoes one directly above the other to save space – way better than side-by-side setups that eat up your whole mudroom floor. The best part: water and dirt from the top pair don't drip down onto the ones underneath. No more gross soggy lower boots.

It prints in 3 easy parts:

• The main body (core rack section)
• 2 optional extenders ( slide on to make room for bigger men's work boots, tall rain boots, etc.)

Without the extenders it's perfect for kids' shoes, small women's boots, or just lighter everyday use. With them added you get that extra height for bigger sizes without redesigning anything.

Total filament for the full set (main + both extenders) is about 340gr , It's built tough – mine's been holding muddy boots for a week with zero flex or breakage. 

Bonus: I included a simple template/ printable fit checker (just 12gr). Print pieces and snap fit together, measure as illustated in picture below  and you'll know right away if it'll fit comfortably before committing to the whole print.

Great for rainy seasons, muddy dogs/kids, construction boots, gardening clogs – anywhere wet & dirty shoes pile up.
Let me know how it holds up for you and if you liked the model!