Search models, users, collections, and posts
Boat Cover Support
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 40% infill
Designer
11 h
1 plate
Open in Bambu Studio
Boost
19
95
5
0
72
60
Released
Description
Hello! This is a boat cover support to hold up your boat cover and reduce pooling. You need a about 1inch diameter rod or pipe. When I measured my pipe it was .95 inches so you might want to check. There are four round holes so you can tie a rope onto the support so it will not fall over. There is also a bulge on the connection so you can wrap a rope around that, and it will not fall lower on the pole. The base is 6.5in wide and the top is around 5 inches. Most sharp edges are rounded so nothing gets cut up. I printed it in PETG I hope you like it!
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (5)