Dragon Emerald Guardian | Miniature

Dragon Emerald Guardian rises with regal intensity, a dragon forged in the hues of deep forest and living flame. His emerald scales shimmer against a molten amber underbelly, while sweeping horns crown a gaze sharp enough to command the skies. Perched upon a rugged stone outcrop, wings unfurled in silent dominion, he stands as a sentinel of ancient realms and forgotten treasures.

Every sculpted scale, every poised talon, captures motion held in perfect stillness, making this 3D model a striking centerpiece for collectors, fantasy worlds, and epic displays alike.

Figure is perfect for dnd games, good for paiting and also not problematic with print.

Check also other figures from my collection:

• Gnoll Miniature
• Serpent Warrior Miniature
• Crocodile Commander Miniature
• Flesh Golem Miniature
• Frostguard Miniature

Recommended settings when printing:
(Not counting the shared print profile)

•  Cooling at 100%
•  Reduce the print speed

 If you have problems with the supports:
    - clean build plate

    - clean build plate again
    - increase the Z-hop

Two figure height versions are available:

• 50mm height, 0.08mm layer,  ---> HIGH DETAIL
• 75mm height, 0.08mm layer,  ---> HIGHT DETAIL
• 100mm height 0.12mm and 0.20mm layer,  ---> HIGH & LOWER DETAIL

Notes on removing the supports:
! Start with wings supports, rocking them slightly from side to side. !

! Wings is the most delicate part of the model. Be careful with it, the rest of the model should be problem-free. !

I hope you enjoy the model I've shared, and that you'll end up with a fantastic miniature or a practical figurine to paint and play with. Thanks you for all likes, downloads, and, above all, prints!