Search models, users, collections, and posts
Pool safety suction cover
IP Report
Print Profile(1)
0.16mm layer, 6 walls, 60% infill
Designer
2.8 h
1 plate
Open in Bambu Studio
Boost
6
11
0
0
10
7
Released
Description
Pool safety suction cover - 115mm
I created this to replace the existing deteriorated wall suction covers in my pool. The fittings were approximately 15 years old and had started breaking up. There are 8 of these in the pool, costing around $30 each to purchase.
They fit perfectly to the Pool-Store branded suction inlet, however will likely fit many similar designs with little to no modification required.
I printed in PETG with 60% infill. Supports are needed for the outer rim.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)