Case for ESP32, SCD40 and LD2450

I bought some ESP32 Wroom 30 pin non-brand chips from AliExpress, and added SCD40 and LD2450 as well. Couldt find a case for it, so I made one. 

I have seen that there are a lot of different designs on these chips, so please check before printing. 

This is the versions with modular terminal, so no soldering, based of on this writeup from vd Brink, but only with the ESP32 instead of the ESP8266. 

The case is functional, and prints well without support. Recommend slow speed on initial layer (15ms have worked for me). 

All my 10 cases have had webbing, but only on the inside, so for me its not an issue. 

Would recommend having a tweezer on hand when assembling. 

I have modified the lid somewhat from the cover photo. Have a look at the photo when its wall mounted, thats the included lid.

UPDATE: The ESP32 and the LD2450 disperse to much heat to get reliable temp readings. Have added a separate enclosure for the SCD40.