Print Profile(1)
Description
Do you like dragons? What kind of question is this, everyone likes dragons. That's why I'm bringing you the model of the eternal sentinel. An armored dragon that will guard your house.
The model has a lot of supports and some of the supports are difficult to remove, so be very very careful when removing them. Be patient.
I recommend printing the model in a smaller layer than 0.2 for better quality, but it's up to you. The print went fine, removing the supports took some time.
Be especially careful in these 2 places so you don't break off the ends of the wings:
Used material is ELEGOO PLA + BLACK
If you decide to print it, I wish you good luck and hope everything goes well.
I slowed down the speed for more success, if you put the speed back to the base profile speed, the print will take just under 10 hours. But I did not test the model at this speed, I preferred to wait 2 hours longer.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (7)