Search models, users, collections, and posts
IKEA Skadis - Wrench holder
IP Report
Print Profile(6)
Standard - 0.2mm layer, 4 walls, 15% infill
Designer
44 min
1 plate
Strong - 0.2mm layer, 6 walls, 25% infill
Designer
49 min
1 plate
2x 3Arms 0.2mm layer, 2 walls, 15% infill
36 min
1 plate
A1 MINI 0.2mm layer, 4 walls, 25% infill
53 min
1 plate
Click to see more
Open in Bambu Studio
Boost
603
2152
157
36
2.3 k
1.7 k
Released
Description
Simple 2 piece holder for up to 8 wrenches, in my case for 6 - 22mm.
There are 2 models, each with different hook position - offset by 20mm. This means you can put them in any column of holes on the Skadis board, depending on lenght of your wrenches.
Files ends with “1” and “2” for different hook position, print one of each or both the same.
This design works with 2 hooks, which is easy to install and remove, but holds very well thanks to the small bumps on the hooks:
Print instructions
- I used PLA, but any material should do
- No supports needed
- 4+ perimeters for added stiffness
- 3MF file with both models + 6 perimeters
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (157)