Search models, users, collections, and posts
Cabling needle
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
1
15
1
0
17
20
Released
Bill of Materials
Bambu Filaments
Select all
Description
This is a size 3.5 cabling needle
I highly recommend sanding with a high grit sandpaper before use, or use vapour smoothing, though I haven't been tested that yet.
Use any material, although PLA and PETG are recommended.
It is also highly recommended to use a .2mm nozzle, though a .4mm nozzle works fine
**NOTE**
When sanding it is necessary to sand the ENTIRE surface, to prevent the wool getting caught.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)