Search models, users, collections, and posts
openConnect on Multiboard snaps
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 0% infill
Designer
48 min
2 plates
Open in Bambu Studio
Boost
3
40
0
0
26
23
Released
Description
Attaches an openConnect connector to a Multiboard snap in order to be able to mount openConnect accessories onto a Multiboard.
Optionally includes connectors offset ±3 mm in the X and Y directions, to make it possible to mount openConnect accessories printed at 28mm spacing on a Multiboard (25mm). The photo shows this setup.
Both “directional” and “hook” snap versions are included. Note that the hook snaps can only be printed either folded or with supports. Both are included in the 3mf file.
I usually print these with 0% infill, but if you want to play it safe, bump it back to the default 15%.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)